HeaterSim

Fired Heater Simulation & Modelling

Multiple Radiant Tube Sizes

Software guidance and support

<<back to support home                                                                                      Get your free trial

Please see the step-by-step guidance notes below. If you still have further questions about this area of using the software, please feel free to contact us


Convection section details fired heater software tutorial - Heater560

1) Click the ‘Radiant Section’ tab.
2) Then click the ‘Edit Radiant Details’ button


Convection section details fired heater software tutorial - Heater560

3) Click the ‘Tubes’ tab.

Convection section details fired heater software tutorial - Heater560

4) Click the ‘Add Section’ button to add a different section of tubes.
The new tube sections will be shown as new tab sections
The size of the tubes in each section can be specified her (as shown above)


Note: When designing heaters with multiple radiant coil sections, Coil Section 1 will be considered as the inlet. The process will then flow to oil Section 2, then to Coil Section 3, and so on.

We hope that this has been useful for you. If you have more questions, you're welcome to contact us


<<Back to Support home





.