HeaterSim

Fired Heater Simulation & Modelling

Radiant tube options - Emissivity, Conductivity, Roughness and Bend K Loss Factors

Software guidance and support

<<back to support home                                                                                      Get your free trial

Please see the step-by-step guidance notes below. If you still have further questions about this area of using the software, please feel free to contact us


Fired Heater Simulation Software - Radiant tube options - Emissivity, Conductivity, Roughness and Bend K Loss Factors

1) Click the 'Radiant Section' tab

2) Then click the 'Edit Radiant Details' button


Fired Heater Simulation Software - Radiant tube options - Emissivity, Conductivity, Roughness and Bend K Loss Factors

3) Then select the 'Tubes' tab and then click 'Tube Options' near the bottom of the window (note that these options will be applied to the tubes specified within this coil section only).

Fired Heater Simulation Software - Radiant tube options - Emissivity, Conductivity, Roughness and Bend K Loss Factors

4) From the 'Tube Options' window that opens, you will be able to specify the Tube Conductivity, Tube Roughness, Tube Emissivity and Bend K Loss factors as desired

We hope that this has been useful for you. If you have more questions, you're welcome to contact us


<<Back to Support home





.