HeaterSim

Fired Heater Simulation & Modelling

'WHRU / Convection Only' modelling

Software guidance and support

<<back to support home                                                                                      Get your free trial

Please see the step-by-step guidance notes below. If you still have further questions about this area of using the software, please feel free to contact us


Wate Heat Recovery Unit WHRU software tutorial - Heater560

1) Click the 'Heater Definition' button, on the main screen


Wate Heat Recovery Unit WHRU software tutorial - Heater560

2) Then select the 'Convection Section Only / WHRU' option and click 'OK'. The Flue Gas definition page will then be opened.

Wate Heat Recovery Unit WHRU software tutorial - Heater560

3) Make sure that at least one of the flue gas stream entry point specified is 'Upstream Convection Section'. 


4) Then enter flue gas details such as temperature, flow rate and composition. Then click 'OK'.


Note: The software program is now set in WHRU mode and simulations carried out will be considered on that basis.

We hope that this has been useful for you. If you have more questions, you're welcome to contact us


<<Back to Support home





.